Adc Campus-REX2 RS Manual de usuario descargar pdf (Pagina 51)

Chapter 3 - Configuring the REX2

Campus-REX2 RS Interface Card User Manual 39

2 If you choose static IP configuration, type then press . At the

prompt, enter the local IP address and subnet mask for the

Campus-REX2 LAN port.

Required format is nnn.nnn.nnn.nnn

Enter IP Address: 10.0.0.1

Enter Subnet Mask (<CR> only=default Mask

255.0.0.0): 255.0.0.0

This parameter must be set for the Campus-REX2 to respond to an

application (such as SNMP, telnet, and FTP) that uses the IP protocol.

The subnet mask allows the Campus-REX2 to determine if a host, such

as an SNMP management station or trap receiver, is on the same local

subnet. If it is, the Campus-REX2 can send messages directly to the host;

if not, messages must be sent through a default router. This must be set

for the Campus-REX2 to respond to applications that use the IP protocol.

3 If you choose static IP configuration, type then press to

configure the default gateway. At the prompt, enter the IP address of the

default gateway through which the Campus-REX2 can reach a host

(SNMP station or trap receiver) on another network. The default value

for this parameter is 0.0.0.0.

Required format is nnn.nnn.nnn.nnn

Enter Default Gateway: 192.150.10.50

6 ENTER

7 ENTER

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 165 166

Sin comentarios

Adc Campus-REX2 RS Manual de usuario Pagina 51