ADC Cuda 12000 Guía de instalación descargar pdf (Pagina 107)

Cuda 12000 IP Access Switch Installation Guide

Cabling Gigabit Ethernet SpectraFlow and POS SpectraFlow Modules 107

Cabling Gigabit Ethernet SpectraFlow and POS

SpectraFlow Modules

The system supports a CableOnce setup for fiber modules, including the

Gigabit Ethernet module, and all POS modules. Instead of cabling directly to

the module, attach the cable to the fiber module backplate that contains a

single blind-mate fiber port. This allows you to remove and replace the

module without having to recable it.

The cabling procedure for both Gigabit Ethernet and POS modules are the

same. Both require installation of a fiber module backplate and use a cable

provided by ADC to connect to the network.

The procedure in this section assumes:

■ You have selected the slot in which to install the Gigabit Ethernet or POS

module, as described in “Determining Module Location” on page 77.

■ You have installed a fiber module backplate on the back of the selected

slot as described in “Backplates” on page 83.

Slot 1 does not accept Gigabit Ethernet or POS modules.

Use the following procedure to cable a slot for connection to a POS or

Gigabit Ethernet module:

1. Insert the AMP MPX connector on the fiber cable into the single port on

the fiber module backplate, as shown in Figure 5-10.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 167 168

Sin comentarios

ADC Cuda 12000 Guía de instalación Pagina 107