ADC MM701G2 Manual de usuario descargar pdf (Pagina 16)

Chapter 1: Installation April 14, 2006

1-2 MM70xG2-UM-03

DETERMINE WHAT YOU NEED

In addition to what is shipped with the modem, you need the following hardware and software to complete the

installation and configuration.

Table 1-1. Required Equipment

Equipment: Requirement:

PC Hardware:

Ethernet NIC Card (10 Mbps) installed in each PC and other network equipment that will be

connected to the LAN. Verify if the NIC in the device which directly connects to the modem

LAN port is half- or full-duplex. The modem LAN port must be set to the same transmission

direction(s) as the NIC.

Optional—serial interface card installed in PC (used for access to the modem console port).

Software:

TCP/IP protocol stack installed (see the operating system documentation for information).

Terminal emulation program (such as HyperTerminal) installed for access to the command

line interface through the console port (see the operating system documentation for

information).

Web browser installed (such as, Internet Explorer

Version 4.0 or higher).

Operating System CD-ROM (Win98, Win98SE, Win2000, WinME, or WinXP).

Ethernet hub,

switch, or router

Optional—use either a hub, switch, or a router to connect multiple PCs or other LAN

equipment to the modem’s Ethernet 10/100Base-T port (LAN port).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 133 134

Sin comentarios

ADC MM701G2 Manual de usuario Pagina 16