ADC MM701G2 Manual de usuario descargar pdf (Pagina 17)

April 14, 2006 Chapter 1: Installation

MM70xG2-UM-03 1-3

CONNECT CABLES

Install cables for the Ethernet port (see “Connect the 10/100Base-T Port” below). Then check “LED Status

Indications” on page 1-5.

Connect the 10/100Base-T Port

Set the modem MDI/MDI-X switch for the 10/100Base-T port to allow the modem to connect directly to other network

devices such as a PC, hub, switch, or router.

Step Action

1 Set the modem MDI/MDI-X switch (see Figure 1-2) to one of the following:

• MDI-X when connecting to a device such as a PC Ethernet NIC card that has an MDI port

• MDI when connecting to a device such as a hub, switch, or router that have MDI-X ports

Figure 1-2. Set the MDI/MDI-X Switch

Note: Make sure the NIC in the PC and the modem LAN port are both set to either half- or

full-duplex for the transmission direction(s). If you need to change the modem LAN port setting

to match the NIC, follow the procedures in “Manage DSL” on page A-17 (half-duplex is the

default setting).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 133 134

Sin comentarios

ADC MM701G2 Manual de usuario Pagina 17