Adc SG-1 Manual de usuario descargar pdf (Pagina 115)

June 30, 2006 Chapter 7: Second Level Commands

SG1-UM-8500-03 7-35

Example(s)

Using the native-ip enable command

This command enables native ip service on a specific interface.

It enables the native IP for a specific VLAN or interface.

Phase 1 should include Ethernet interface and VLAN-Id only.

Phase 2 should include interface atm.

Usage

native-ip enable interface [<Ethernet<slot\port> | VLAN <slot\port\identifier> |

ATM <slot\port\sub-interface> | tunne <tunnel interface id> | l2transport <destina-

tion> <vc-id>

Parameter(s)

<slot\port>

This is the Ethernet slot number (valid number range is 0 to 2) and Ethernet port number (1 or 2).

<slot\port\identifier>

This is the Ethernet slot number (valid numbers 0 to 2), Ethernet port number (1 or 2), and VLAN identifier (1 to ?).

<slot\port\sub-interface>

This is the Ethernet slot number (valid number range is 0 to 2), Ethernet port number (1 or 2), and VLAN identifier

(sub-interface valid number 1 to 4095).

This is the tunnel interface identifier. Valid number range is 1 to 300.

This specifies the LDP IP address of the remote PE. It must be a valid IP address.

<vc-id>

This assigns a VC ID to the virtual circuit between the system and the remote PE.

Host(config)# native-ip def-service-auth werbcvxsaq

Host(config)# native-ip enable interface

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 225 226

Sin comentarios

Adc SG-1 Manual de usuario Pagina 115