Adc SG-1 Manual de usuario descargar pdf (Pagina 36)

Chapter 5: Using the Command Line Interface June 30, 2006

5-2 SG1-UM-8500-03

WHAT TO DO NEXT

From the command-line interface, use the procedures in this manual to (among other things):

• Configure the network card ports, followed by services for the network connections, including Automatic Pro-

tection Switching (APS) for the OC3 card.

• Configure ATM traffic, including traffic profiles, policing, packet discard, over-subscription, and traffic shaping

for Unspecified Bit Rate (UBR) traffic.

• Set up ATM routing parameters for either IISP (static ATM routing) or Private Network to Node Interface

(PNNI) dynamic ATM routing.

• Set up system ATM configuration, such as signaling characteristics, ATM prefixes and addresses, ATM inter-

faces, and aliases for ATM addresses.

• Configure ATM connections for Permanent Virtual Circuits (PVC's).

• Set up bridging and routing global parameters and sessions over PVC's.

• Set up an IP/Ethernet uplink (bridging and routing over ATM PVC's) using an SCC card.

Use Table 3-1 on page 3-1 to navigate command menus and perform the necessary actions.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 225 226

Sin comentarios

Adc SG-1 Manual de usuario Pagina 36